ATCOM AT800 Series Manual do Utilizador descarregar pdf (Página 17)

AutoTune™ User Guide

4.5. Distortion

Note: This test is not supported for Motorola ASTRO® XTL™ Series High Power

models.

This is a test only; there is no alignment.

RF Control

Port

Frequency

Modulation

Level

Generate

RF IN/OUT

Test Freq

FM, 1 kHz @ 3 kHz deviation

-50 dBm

Table 4-14. Analyzer Configuration for Distortion Test

4.5.1. Alignment

No alignment is needed.

4.5.2. Test

The analyzer is setup as specified in this section’s Analyzer Configuration table. The

radio is placed into Test Mode at the lowest RX Test Frequency. The radio audio output

level is tested and if insufficient to measure distortion the volume is increased until

sufficient to measure distortion. The audio signal’s distortion level is then measured and

compared to test limits. The final results are written to the log file.

Name

Description

Result

Pass or Fail. Distortion level within Max Limit, Min Limit

Frequency

Test Frequency

Distortion

Measured audio signal distortion level

Max Limit

Maximum Limit (inclusive) for Distortion to Pass

Table 4-15. Distortion test results

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

Sem comentários

ATCOM AT800 Series Manual do Utilizador Página 17